Gas exchange processes in two-stroke internal combustion engines, commonly referred to as scavenging, are responsible for removing the exhaust gases in the combustion chamber and preparing the combustible fuel-oxidizer mixture that undergoes combustion and converts the chemical energy of the fuel into mechanical work. Scavenging is a complicated phenomenon because of the simultaneous introduction of fresh gases into the engine cylinder through the intake ports, and the expulsion of combustion products from the previous cycles through the exhaust ports. A non-negligible fraction of the gaseous ...
Gas exchange processes in two-stroke internal combustion engines, commonly referred to as scavenging, are responsible for removing the exhaust gases in the combustion chamber and preparing the combustible fuel-oxidizer mixture that undergoes combustion and converts the chemical energy of the fuel into mechanical work. Scavenging is a complicated phenomenon because of the simultaneous introduction of fresh gases into the engine cylinder through the intake ports, and the expulsion of combustion products from the previous cycles through the exhaust ports. A non-negligible fraction of the gaseous mixture that is trapped in the cylinder at the conclusion of scavenging is composed of residual gases from the previous cycle. This can cause significant changes to the combustion characteristics of the mixture by changing its composition and temperature, i.e. its thermodynamic state. Thus, it is vital to have accurate knowledge of the thermodynamic state of the post-scavenging mixture to be able to reliably predict and control engine performance, efficiency and emissions. Two tools for estimating the trapped mixture state - a simple scavenging model and empirical correlations - were developed in this study.
Unfortunately, it is not practical to directly measure the trapped residual fraction for engines operating in the field. To overcome this handicap, simple scavenging models or correlations, which estimate this fraction based on some economically measurable engine parameters, can be developed. This report summarizes the results of event-II of a multi-event project that aims to develop such mathematical formulations for stationary two-stroke natural gas engines using data from more advanced models and experimentation. In this event, results from a GT-Power based model for an Ajax E-565 single-cylinder engine are used to develop a three-event single zone scavenging model and empirical correlations. Both of these mathematical devices produce accurate estimates of the trapped mixture state. The estimates are compared to GT-Power results. In the next event of the project, these results will be validated using experimental data. Various steps followed in the development of the model have been discussed in this report, and at the end some results and recommendations for the next event of the project have been presented.